img_7717-2
img_7723
img_7734
img_7798
img_7800

An easy to build outdoor kids picnic table and benches. The perfect spot for little ones to eat, draw and play! Cedar elevates this table and seating to be elegant for the younger crowd and durable for outdoors.

Difficulty moderate

Tools

Kreg Tools

Other Tools

  • Miter Saw
    Miter Saw
  • Square
    Square
  • Tape Measure
    Tape Measure
  • Chisel
    Chisel
  • Clamps
    Clamps
  • Drill (cordless)
    Drill (cordless)
  • Sawhorse
    Sawhorse

Materials

Wood Products

  • 12 Board , 1x4 , 48"
  • 8 Board , 1x3 , 48"

Hardware & Supplies

  • 1 Wood Glue
  • 150 1 1/4" Kreg Screws

Cut List & Parts

  • 6 Table Top Boards , 1x4 x 48"
  • 3 Table Top Supports , 1x3 x 21"
  • 4 Table Legs , 1x3 x 28" Cut at 40º
  • 2 Table Leg Supports , 1x3 x 22 7/8 cut at 25º
  • 6 Bench Top Boards , 1x4 x 40"
  • 6 Bench Top Supports , 1x3 x 10 1/2"
  • 8 Bench Legs , 1x3 x 12" cut at 40º
  • 4 Bench Leg Supports , 1x3 x 17" cut at 9º

Directions

  • Mark The Supports for the Tabletop

    Take the six 48" lengths of 1x4 and lay next to a each other with the tops facing down. Leave a gap of 1/8" between each. Use one of 1x3 21" length and lay evenly across the top, marking the gaps in between the 1x4's. Copy the marks onto the other two 21" lengths of 1x3.

  • Drill Pocket Holes in Supports

    Drill two pocket holes in between each of the marks on all three lengths.

  • Attach the Supports to the Top

    Place two of the lengths 1 1/2" in from the ends tabletop, making sure the pocket holes are on the inside. Take the third piece of 1x3 and attach across the middle.

  • Create Legs

    Lay two of the leg pieces (28" length of 1x3 cut at 40º angles). Mark where they meet and cut cross halving joint in each using either a miter saw and chisel or a router. The cuts should be 10º from perpendicular. Attach to each other with wood glue.

  • Attach Legs to Table

    Cut pocket holes on the inside of the tops of the legs and attach.

  • Attach Leg Supports

    Take the two leg supports (22 7/8" of 1x3, cut at 25º from perpendicular), drill pocket holes into each end and attach between the cross of a leg and the center tabletop support.

  • Create Benches

    Repeat above steps but with three 40" lengths of 1x4 and the smaller supports and the leg pieces detailed in the cut list. Note: if you want higher benches, the lengths of the legs, the leg supports and the cut angles will be different.