bookcase-with-toy-storage-2-rogue-engineer
bookcase-with-toy-storage-rogue-engineer
bookcase-with-toy-storage-3-rogue-engineer

If you have kids then you know how important toy storage is. This wall unit now only gives you a ton of toy storage but it incorporates a book shelf for all those nighttime stories.

Check the extras tab for a PDF download of these plans and cut list.

Difficulty moderate

Tools

Kreg Tools

Other Tools

  • Circular Saw (cordless)
    Circular Saw (cordless)
  • Jigsaw
    Jigsaw
  • Square
    Square
  • Table Saw
    Table Saw
  • Tape Measure
    Tape Measure
  • Drill (cordless)
    Drill (cordless)
  • Nail Gun
    Nail Gun
  • Sander
    Sander

Materials

Wood Products

  • 2 Plywood , 3/4" Thick , Full Sheet
  • 1 Baseboard Trim , 3-1/4" , 48"
  • 1 Decorative Moulding , 3/4" Thick , 48"

Hardware & Supplies

  • 100 1-1/4" Pocket Screws
  • 100 1-1/4" Brad Nails

Cut List & Parts

  • 2 Sides , 3/4" x 20" x 38"
  • 1 Mid Panel , 3/4" x 19-1/8" x 34-1/2"
  • 1 Top , 3/4" x 12-1/2" x 42"
  • 1 Front , 3/4" x 10-1/2" x 40-1/2"
  • 1 Bottom , 3/4" x 16-1/2" x 40-1/2"
  • 1 Support , 3/4" x 2-3/4" x 16-1/2"
  • 2 Shelf , 3/4" x 9-1/2" x 19-7/8"
  • 1 Shelf Front , 3/4" x 2" x 40-1/2"
  • 2 Back , 3/4" x 19-7/8" x 34-1/2"

Directions

  • Cut Sides and Mid Panel

    Use the diagrams shown to draw two sides and one middle panel. Then cut out using a circular saw and jig saw.

  • Assembly

    Drill pocket holes and begin assembly as shown using 1-1/4" pocket screws.

  • Assembly

    Drill pocket holes and continue assembly as shown using 1-1/4” pocket screws.

  • Assemble Shelf

    Drill pocket holes and assemble shelf as shown using 1-1/4” pocket screws.

  • Install Shelf and Trim

    Install shelf as shown using 1-1/4” pocket screws.
    Cut base board trim and decorative moulding to length and install using 1-1/4” brad nails.

    For more plans like this be sure to visit RogueEngineer.com