img_3318
img_3330
img_3273
img_3278
img_3282
diy-table-top-with-pocket-holes

This kitchen tabletop is so easy to build, even for beginners. We incorporated pocket hole joinery to join the table slats together and used an old table base from something we already had and repainted it!

Difficulty easy

Tools

Kreg Tools

Other Tools

  • Jointer
    Jointer
  • Miter Saw
    Miter Saw
  • Square
    Square
  • Table Saw
    Table Saw
  • Tape Measure
    Tape Measure
  • Clamps
    Clamps
  • Drill (cordless)
    Drill (cordless)
  • Hammer
    Hammer
  • Impact Driver
    Impact Driver
  • Sander
    Sander
  • Air Compressor
    Air Compressor
  • Shop Vacuum
    Shop Vacuum
  • Workbench
    Workbench
  • Tape Measure
    Tape Measure

Materials

Wood Products

  • 3 Board , 2x6 , 144"

Hardware & Supplies

  • 46 1 1/2" Pocket Hole Screws (Zinc)
  • 1 Wood Glue
  • 1 Wood Stain
  • 1 Polyurethane
  • 8 1 1/2" Cabinet Screws (to attach table to base)

Cut List & Parts

  • 6 Table Slat , 1 1/2" x 6" x 34"
  • 2 Short Side Table Border Slat , 1 1/2" x 5" X 40"
  • 2 Long Side Table Border Slat , 1 1/2" x 5" x 44"

Directions

  • Run wood through jointer

    To ensure that your board edges and faces are completely flat, it's best to run them through a jointer on all sides. This will help the boards fit tight together when you create the tabletop.

    Don't have a jointer? Even just running each board through a table saw on each edge to remove the rounded edges that you'll find on store bought lumber will make a big difference.

  • Drill pocket holes

    Layout the boards in the correct arrangement as shown in the woodworking plans and mark the areas that you'd like to drill the pocket holes.

    Next, using a Kreg pocket hole jig, drill all pocket holes according to the depth of your wood.

  • Cut wood

    Cut all wood down to size according to the cut list in the woodworking plans with the miter saw. For the wood materials, we used cedar.

  • Assemble table slats

    Start by gluing all middle slats together, screwing in at all pocket holes and clamping interior slats together. Wait for glue to dry before moving on.

  • Sand and square table interior

    Sand down the middle slats with belt sander until level with 80 grit sandpaper. Square each edge with a table saw or Kreg's Rip-Cut.

  • Add border slats

    Add miter cut border slats around the edge of the table and attach with wood glue and screws at pocket holes. Clamp and let dry.

  • Sand table top flat

    Sand your table top with belt sander and 80 grit sandpaper so all areas are flat and flush with each other.

  • Fill gaps and sand

    Fill gaps with wood filler or sawdust mixed with wood glue from sanding and then sand down with an orbital sander, working your way from 80 to 220 grit sandpaper.

  • Stain and finish

    Stain your table top and apply finish.

  • Assemble table

    Attach table top to base with screws. Our table base had a platform already attached (from the old table), but if yours doesn't you would want to incorporate a base using plywood.

    While assembling, be sure to make sure the top is level. Because our floor was not completely level, we ended up adjusting by adding shims under the tabletop between installing to the base.