diy-rustic-x-leg-console-table-anikas-diy-life-4
diy-rustic-x-leg-console-table-anikas-diy-life-2
diy-rustic-x-leg-console-table-anikas-diy-life-6
diy-rustic-x-leg-console-table-anikas-diy-life-700-25

Looking for the perfect entryway table? This X-leg Console table combines style and function. The shelves provide added storage and can look amazing when styled. This unique design blends right in with any decor – farmhouse or modern.

Difficulty moderate

Tools

Kreg Tools

Other Tools

  • Miter Saw
    Miter Saw
  • Drill (cordless)
    Drill (cordless)
  • Sander
    Sander

Materials

Wood Products

  • 2 Board , 2x4 , 96"
  • 3 Board , 2x6 , 120"

Hardware & Supplies

  • 50 2 1/2" pocket hole screws
  • 6 1 1/2" wood screws
  • 1 Wood glue
  • 1 Wood filler

Cut List & Parts

  • 4 Leg Supports , 2 x 4x 16 1/2"
  • 1 Bottom Divider , 2x6x12 3/4"
  • 2 Top divider , 2 x 6 x 14 1/4"
  • 3 Top , 2 x 6 x 50"
  • 2 Middle shelf , 2 x 6 x 39 1/8"
  • 2 Bottom Shelf , 2 x 6 x 37 1/8"
  • 2 Long Angled cut (see picture) , 2 x 4 x 30"
  • 4 Short Angled Cut (See Picture) , 2 x 4 x 15

Directions

  • Build the legs

    Drill 1 1/2" pocket hole screws and attach the long angled cut to the legs supports using 2 1/2" pocket screws.
    Attach the short angled cuts using 2 1/2" pocket screws to create the X.
    Note - the 40-degree angle is towards the middle of the X.

  • Build shelves and Top

    Drill 1 1/2" pocket hole screws and put together the two shelves and top using 2 1/2" pocket screws.

  • Attach legs to top

    Lay the top face down and attach the two X-legs using 1 1/2" wood screws drilled into the leg supports.
    Make sure the pocket holes face inside.

  • Attach middle shelf

    Attach the top dividers and the middle shelf.
    Use 1 1/2" pocket holes and 2 1/2" pocket screws.

    The dividers are 12 1/4" from each end.
    The shelf is 13 1/2"" from the Top.

    There are pocket holes on the ends of the shelf that attach to the middle of the X.

  • Attach bottom shelf

    Attach the bottom divider and the bottom shelf using 1 1/2" pocket holes and 2 1/2" pocket screws.
    The divider is 18 1/4"" from one end.

    The Bottom shelf is attached to the leg supports using pocket holes and screws.

  • Final steps

    The X-leg console table is ready.

    Sand and finish as desired.

  • Visit anikasdiylife.com

    For lots more plans and projects visit www.anikasdiylife.com