Round Marble and Wood Side Table

 Write Review

jenwoodhouse added on 11/9/2017

Add a modern touch to your living space with this sleek round side table featuring a (faux!) marble top and natural wood base.

Directions

Follow the steps below to complete this project.

1

Cut the Boards

Using the cut list, measure, mark, and cut the 2x2 boards to length.

2

Drill Pocket Holes

Using a Kreg pocket hole jig, drill 1 1/2-inch pocket holes into the ends of all of the stretchers. Notice that the pocket holes in the top rails are placed on the top (the tabletop will cover them) while the pocket holes in the bottom rails are hidden underneath.

3

Construct the Table Base

Construct the table base as shown with 2 1/2-inch pocket screws and wood glue. The stretchers are placed 3/4" inset from the edges of the legs. I chose to use pocket hole joinery here, but in hindsight, if I were to build this table again, I would use pocket screws to attach the stretchers to the legs and use a half lap joint at the cross sections. Sand, stain and/or paint, and finish as desired.

4

Apply Marble Contact Paper to Top

Cut out adhesive contact paper to size. Peel the backing and apply the contact paper to the wood round. I found the marble contact paper on Amazon. Alternately, if you'd like to use a real marble slab, you can often find inexpensive stone remnants at your local granite installer.

5

Smooth Out Any Bubbles

Smooth out any bubbles in the contact paper with a straight edge.

6

Cover the Edges

To cover the rounded edge of the table top, use a hairdryer to apply heat as you pull the contact paper over the edge. The heat will stretch the contact paper and remove any wrinkles.

7

Attach the Top

Pre-drill pilot holes into the top rail of the table base. Attach the top with 2-inch wood screws and wood glue driven from underneath.

Tools Used:

Materials Required:

Wood Products:

(2) 2x2, 96", Board  
(1) 3/4" Thick, 24", Round Wood Project Panel  

Hardware/Supplies:

Parts/Cut List:

(4) Legs, 1 1/2" x 1 1/2" x 23 1/2"  
(2) Long Stretchers, 1 1/2" x 1 1/2" x 24"  
(4) Short Stretchers, 1 1/2" x 1 1/2" x 11 1/4"  
(1) Round Top, 24" diameter  

Extras:

https://jenwoodhouse.com Visit

Discussion

You must log in to add comments

Login

    Become a Member

    Explore

    • Connect with the BuildSomething Community
    • See what others build and share your stories

    Contribute

    • Find inspiring ideas for your projects you can build
    • Get the step-by-step plans you need to succeed

    Share

    • Turn your projects into professional-looking plans
    • Share your plans you create on buildsomething.com

    OR

    CONNECT USING

    Already a member?
    Sign in!

    Kreg Tool