Planter Box

 Read Reviews (1)

viktordub@hotmail.com added on 7/1/2019

I built this DIY Planter Box few years back with pressure treated lumber and corrugated steel roof panels on the sides. Over the years we had many different vegetables grown in the planter box. I love how it looks and it holds a lot of dirt for vegetable plants with deep roots.

Directions

Follow the steps below to complete this project.

1

Cut and Assemble Long Sides

Since this planter box is for outdoors and will be exposed to moisture, it’s a good idea to use pressure treated wood. Pressure treated wood is commonly used for outdoor fencing. Start with making the long side of the planter box. Cut boards per provided dimensions in the cut list and drill pocket holes using Kreg Jig. Assemble using 2 1/2" Pocket Hole Screws. You will need two long sides and two short sides.

2

Assemble Short Side

Similar to step 1, cut per dimensions provided in the cut list and assemble using 2 1/2" Pocket Hole Screws. The 26" long 2x4 will need to have 3 pocket holes drilled on each side. These pocket holes will be used to attach to the long sides of the planter box.

3

Attach Both Short and Long Sides To

Place all sides on a flat surface and attach using 2 1/2" Pocket Hole Screws.

4

Add Bottom Blocks

Flip the planter box upside down. Take 2x6 and cut 5 boards to 29" in length. Place two boards at each side and the remaining three evenly spaced out. Then attach all boards with 2 1/2" Wood Screws.

5

Place Sheet Metal Inside

The bottom of the box will need to be covered with either a flat sheet metal or with Corrugated Steel Roof Panel. Drill bunch of 1/4" holes thru metal for water drainage.

6

Fasten Corrugated Steel Roof Panels

For the last step, place Corrugated Steel Roof Panels on all four sides attaching it with wood screws. Use red sheet metal snips to cut panels for the short sides. Using wood screws attach one 2x4 on top. This will prevent the box from coming apart once dirt is added inside. Metal angle or metal wire could be an alternative to 2x4 on top if you prefer not to use it.

Tools Used:

Materials Required:

Wood Products:

(6) 2x4, 96", Board  
(3) 2x6, 96", Board  

Hardware/Supplies:

Parts/Cut List:

(4) Frame, 1 1/2" x 3 1/2" x 65  

Extras:

https://thediyplan.com/diy-planter-box/ Visit
https://thediyplan.com/ Visit

Discussion

You must log in to add comments

Login

    Become a Member

    Explore

    • Connect with the BuildSomething Community
    • See what others build and share your stories

    Contribute

    • Find inspiring ideas for your projects you can build
    • Get the step-by-step plans you need to succeed

    Share

    • Turn your projects into professional-looking plans
    • Share your plans you create on buildsomething.com

    OR

    CONNECT USING

    Already a member?
    Sign in!

    Kreg Tool