Easy Build Workbench

 Read Reviews (3)

home made by carmona added on 9/25/2016

This workbench is an easy build, but makes for a super sturdy and sleek styled basic workbench! Build more than one for a modular system of benches that can be customized to fit your needs, and rolled wherever needed!

Directions

Follow the steps below to complete this project.

1

Drill Pocket Holes

After making all your cuts (or having it done at the hardware store), drill two pocket holes into each end of the 2"x4"x26" boards.

2

Assemble 2 Tabletop Frames

Assemble two tabletop (shelf) frames by screwing in the 2"x4"x26" boards via pocket holes into your 2"x4"x48" boards. Be sure to do this on a flat even surface and use a carpenter square to ensure a proper 90 degree angle.

3

Nail Birch Plywood Atop Frame

Using 2" finishing nails, center and nail down your two birch plywood pieces atop the two tabletop frames you just built. The 32" piece of birch must be centered so that there is a 2" overhang on either side.

4

Lay Out 2"x6" Legs

Lay out two of your 2"x6"x25.5" legs, approximately 40" apart.

5

Place 1st Tabletop

Carefully lay the 48"x32" tabletop (without the overhang) flush with the bottom and sides of the 2"x6" legs. The birch plywood should face upward toward the extended legs.

6

Place 2nd Tabletop

Next carefully balance the tabletop WITH the overhang just over the 2"x6" legs. The legs should be flush with the sides of the tabletops, and the top and bottom.

7

Screw Tabletops To Legs

After both tabletop pieces are flush with the legs, attach them from the top inside with screws. Just screw directly through the 2"x4" tabletop frame into the 2"x6" wooden legs beneath.

8

Add Next Set of Legs

Finally add the last two 2"x6" legs to the top open side. Again, make sure the tabletop is flush with the legs on the bottom and sides. Screw into place from the top this time. Flip it over, so you can secure with screws from the inside and outside of both leg pieces.

9

Add Casters

Add casters to the four bottom corners. Sand any rough edges, and it is ready for use!

Tools Used:

Materials Required:

Wood Products:

(1) 4x8, Full Sheet, Birch  
(2) 2x6, 96", Board  
(4) 2x4, 96", Board  

Hardware/Supplies:

Parts/Cut List:

(1) Birch plywood, 1/2"x48"x32"  
(1) Birch plywood, 1/2"x48"x29"  
(4) Tabletop frame, 2"x4"x48"  
(4) Tabletop Frame, 2"x4"x26"  
(4) Legs, 2"x6"x25.5"  

Extras:

http://www.homemadebycarmona.com/ Visit

Discussion

You must log in to add comments

Login

    Become a Member

    Explore

    • Connect with the BuildSomething Community
    • See what others build and share your stories

    Contribute

    • Find inspiring ideas for your projects you can build
    • Get the step-by-step plans you need to succeed

    Share

    • Turn your projects into professional-looking plans
    • Share your plans you create on buildsomething.com

    OR

    CONNECT USING

    Already a member?
    Sign in!

    Kreg Tool